U
SING
P
RINT
M
ATERIALS
3.14
2
Adjust the guide to fit the width of the transparencies.
3
When you print on transparencies, you must select Manual
Feed for Source from the software application, and then
select the correct paper size and type. For details, see
page 4.6.
Note: Please be careful when you open the rear cover. The inside
of the printer maybe hot.
4
Press the button to start feeding.
Printing is started. Close the rear output tray after the
printing is completed.
Notes:
• To prevent transparencies from sticking to each other, do not let
the printed sheets stack up as they are printed out.
• Place transparencies on a flat surface after removing them from
the printer.
To Next Page
Loading...
Need help?
General