Maintenance
Phaser 6000/6010 Color Printer
User Guide
17
Cleaning the Exterior
Clean the exterior of the printer about once a month. Wipe the parts with a damp, soft cloth. Then
wipe with another dry, soft cloth. For stubborn stains, apply a small amount of neutral detergent to the
cloth and gently wipe the stain off.
Cleaning the Interior
After clearing paper jams or replacing one of the toner cartridges, inspect the inside of the printer
before closing the printer covers.
Remove any remaining pieces of paper. For more information, see Paper Jams in the Quick Use Guide.
Remove any dust or stains with a dry, clean cloth.
CAUTION: Do not spray the detergent directly on the printer. The liquid detergent
could enter the printer through a gap and cause problems. Never use cleaning
agents other than water or neutral detergent.
WARNING: Never touch a labeled area found on or near the heat roller in the fuser.
You can get burned. If a sheet of paper is wrapped around the heat roller, do not try
to remove it immediately to avoid injuries or burns. Switch off the printer
immediately and wait 40 minutes for the fuser to cool.
To Next Page
Loading...
Need help?
General