Installation and Setup
30 Phaser 7800 Color Printer
User Guide
Modifying General Settings
You can modify printer settings such as the language, date and time, units of measurement, display
brightness, and startup page from the control panel.
1. At the control panel, touch Printer.
2. Touch the Tools tab, then touch Setup.
3. Touch General Settings, then touch the setting you want to change:
Language/Keyboard allows you to set the language and keyboard layout.
Date/Time allows you to set the time zone, date, time, and display format.
Note: The date and time are automatically set through Network Time Protocol (NTP). To modify
these settings, go to the Properties tab in CentreWare Internet Services and change the Date and
Time Setup to Manual (NTP Disabled).
System Timeout allows you to specify how long the printer waits for input before returning to
the main screen.
Display Brightness allows you to set the brightness level of the touch screen.
Startup Page allows you to specify if the Configuration Report prints each time the printer is
turned on.
4. Change settings as needed.
5. To confirm the change, touch OK, or X to cancel it.
6. Modify other settings, or touch Home to return to the main screen.
To Next Page
Loading...
Need help?
General