Xerox Phaser 860 Networking Setup Guide

Networking Setup Guide 15
Setting the Printer’s IP Address
Setting the IP Address From the Front Panel
1. With Menus highlighted, press the OK key.
2. Press the Scroll Down key to scroll to the Network Setup Menu.
3. Press the OK key.
4. Scroll to TCP/IP Address.
5. Press the OK key.
6. Press the Scroll Down or Scroll Up key to scroll to the correct number for the first
digit of the address, then press the OK key to accept that digit.
7. Repeat step 5 for each remaining digit.
8. Scroll to TCP/IP Network Mask.
9. Press the Scroll Down or Scroll Up key to scroll to the correct number for the first
digit of the address, then press the OK key to accept that digit.
10. Repeat step 9 for each remaining digit.
11. Scroll to TCP/IP Gateway.
12. Press the Scroll Down or Scroll Up key to scroll to the correct number for the first
digit of the address, then press the OK key to accept that digit.
13. Repeat step 12 for each remaining digit.
14. To exit the menu system, scroll to Exit and press the OK key.

Xerox Phaser 860 Specifications

General

Brand	Xerox
Model	Phaser 860
Category	Printer
Language	English