Xerox Phaser 860 Networking Setup Guide

32 Phaser 860 Color Printer
Network Protocols
Disabling and Enabling Protocols Using the Front
Panel
1. With Menus highlighted, press the OK key.
2. Scroll to Network Setup Menu by pressing the Scroll Up or Scroll Down key.
3. Press the OK key.
4. Scroll to DHCP/BOOTP, TCP/IP, EtherTalk, NetWare, or IPP.
5. Press the OK key.
6. Scroll to display either On or Off.
7. Press the OK key.
8. To exit the menu system, scroll to Exit and press the OK key.
Disabling Protocols Using CentreWare IS
1. Connect to the printer via CentreWare IS (see page 23).
2. On the main CentreWare IS page, click Properties.
3. On the left side of the page, in the Protocols group, select the protocol to be disabled.
This displays the page for that protocol.
4. On the page are fields labeled with the settings for the protocol. To disable a setting or
protocol, select Off
5. Click Save Changes at the bottom of the page.

Xerox Phaser 860 Specifications

General

Brand	Xerox
Model	Phaser 860
Category	Printer
Language	English