Making Copies
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
Getting Started
21
Making Copies
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch the
documents.
Or...........
Lift up the document feeder. Place the document face down onto the document glass and register
it to the arrow at the top right rear corner. Close the document feeder.
2. Press the Clear All (AC) button once to cancel any previous screen programing selections.
3. Press the Services Home button and select the Copy
option.
The Copy features are displayed.
4. Select the required features using the touch screen:
5. Enter the copy quantity using the numeric keypad and press Start to scan the originals.
6. Remove the originals from the document feeder or document glass when scanning has completed.
Note: The Copy job enters the job list ready for printing.
7. Select Job Status to view the job list and check the status of your job.
If your job is held in the list it requires additional resources to print. To identify the resources
required, select the job and select Job Details. Once the resources are available the job will print.
For information about additional Copy features, refer to Copy Options on page 44 of Copy.
For information about copying an ID card, refer to Copying an ID Card on page 204 of ID Card Copy.
Reduce / Enlarge can be used to reduce or enlarge the image by 25% to 400%.
Paper Supply is used to select the required tray and size of paper for the copy output.
2-Sided Copy is used to produce 1 or 2-sided copy output.
Copy Output is used to select collate, staple or fold options (depending on the finishing
device available).
To Next Page
Loading...
Need help?
General
