Care and maintenance
2. Assembly
Install the defoamer elements on top of each other and connect.
Position the defoamer hole to align with the steam outlet, press the
defoamer to install (As shown in the figure).
Incorrect installation of the defoamer can cause burns and
damage to the device!
Put the inner cover on the holders and insert it inward until a
characteristic locking click is heard.
Note: Before starting work, be sure to install the inner cover, otherwise the
cover of the device will not close.
Important Notes
Operating restrictions
● The device is intended for use at altitudes between 0 and
2000 m;
● The device should not be placed on unstable or damp
surfaces, as well as close to sources of heat or open flame,
the optimal distance is at least 30 cm;
● To avoid overheating and damage to the device or personal
injury, do not use a boiler that is not designed for the device
or a deformed boiler.
Power cable
● Use only the supplied power cable; ● Before servicing or
moving the device, unplug the power cord from the outlet;
● If the cable is damaged, it must be replaced with an original
cable with equivalent characteristics;
● To avoid damage to the core, do not twist, pinch or bend the
cable, otherwise it may cause problems with the power
supply of the device.
Important Notes
Device Power
● To prevent fire and electric shock, do not use any power
source other than AC 220V;
● When disconnecting the device from the power supply, hold
the plug. To avoid short circuit and electric shock, do not pull
To Next Page
Loading...
Need help?
General
