Xilinx Zynq-7000 Getting Started Guide

4 www.xilinx.com ZC702 and ZVIK Getting Started Guide
UG926 (v6.0) December 17, 2013
02/12/2013 3.0.1
Removed stray internal draft banner from the cover page, and from the first page in
each chapter and appendix.
05/14/2013 4.0
Deleted “Key Features of the ZC702 Evaluation Board” section. The Base TRD Key
Features, page 27 were updated for the Programmable Logic (PL) to “One
Performance Monitor”. The required binaries in Base TRD Hardware Setup
Requirements, page 28 were updated to include “zynq-zc702-base-trd.dts“.
Port “P1” was labelled in Figure 3-2. Figure 3-6 and Figure 3-7 were replaced to
illustrate the QT-based GUI and minimized GUI mode. In Running the Video
Demonstration for 720p Video Resolution, page 38, the instructions were updated for
running QT based GUI in 720p mode and running the UART Menu based
Demonstration Application in 720p mode.
08/12/13 5.0
Draft
Updated document for Vivado Design Suite 2013.2. Added Command Line Application
block to Figure 3-1. Updated binaries under Base TRD Hardware Setup Requirements.
Updated commands under Running the Qt-Based GUI Application Demonstration,
Running the UART Menu-Based Demonstration Application, and Running the Video
Demonstration for 720p Video Resolution. Updated Figure 3-9 and Figure 4-1.
Updated Requirements to Get Started (modified steps 3 and 4 and deleted step 5).
Updated Evaluating AMS steps 2 and 3.
10/21/13 6.0
Draft
Updated document for Vivado Design Suite 2013.3. Updated Figure 3-6, Figure 3-7,
and Figure 3-9. Updated zynq> commands (changed sobel_qt to run_sobel.sh).
Date Version Revision
Send Feedback

Xilinx Zynq-7000 Specifications

General

Brand	Xilinx
Model	Zynq-7000
Category	Motherboard
Language	English