12
motor and high-speed application is 48V.
DP3F-808 range is 20~80VDC: recommended value is above 48V.
3-5-2. Power supply requirements
The power supply voltage can work normally within the calibration range. The driver should preferably use
non-regulated DC power supply, or use transformer + bridge rectifier + capacitor filter. It is recommended that
users use 24V-48VDC power supply to avoid grid fluctuation exceeding the working range of driver voltage. If
the regulated switching power supply is used, the switching power supply output current range should be set to the
maximum.
Note:
(1) Do not reverse the power supply voltage!
(2) Do not exceed the working range of the power supply to ensure the normal operation of the driver.
(3) The power supply should be non-regulated DC power supply, and the output capacity of the power supply
should be greater than 60% of the set current of the driver.
(4) If the stabilized voltage switching power supply is used for power supply, the output current range of the
power supply should be greater than the working current of the motor.
(5) In order to save space, two or three drives can share one power supply, but the power supply should be large
enough.
To Next Page
Loading...
Need help?
General
