27
SHOCK POSITION ADJUSTMENT
RIDE HEIGHT ADJUSTMENT
DROOP ADJUSTMENT
BAG
07
902306
SH M3x6
981212
P 2x12
902308
SH M3x8
OPTIONAL INITIAL POSITION
L=R
308302
902308
902306
981212
301332
TECH TIP:
To make the car more stable and easier to drive, move the rear shocks rearward. Stability increases
mainly in chicanes. Note that the car will have less steering into corners.
• Upper mount (shock tower): Add a plastic nut and use a longer screw 3x8mm (NOT INCLUDED) to
space the upper end of the shock away from the shock tower.
• Lower mount (lower arm): Add shims and use a longer setscrew 3x10mm (NOT INCLUDED) on the
lower arms to space the lower end of the shock away from the arm.
When using optional 2-hole arms and optional
1-hole rear upright, use the second hole from the
bottom on the shock tower.
7. FRONT & REAR ASSEMBLY
30 1332 REAR BODY MOUNT SET 6MM
90 2306 HEX SCREW SH M3x6 (10)
90 2308 HEX SCREW SH M3x8 (10)
98 1212 PIN 2x12 (10)
30 8301 T2 XRAY SHOCK ABSORBER-SET 4-STEP - SHORT (2)
30 8306
XRAY T2’008 ALU SHOCK ABSORBER-SET (2) (OPTION)
REAR SHOCK
(C2 .6 SPRING - EU RUBBER-SPEC)
L=R
INITIAL POSITION
REAR SHOCK
(WHITE SPRING - US FOAM-SPEC)
INITIAL POSITION
INITIAL POSITION
EU RUBBER-SPEC
US FOAM-SPEC
308019 Set of Shock
Shims & Nuts
To Next Page
Loading...
Need help?
General
