To Next Page

To Previous Page

GEARING ADJUSTMENT

902306

SH M3x6

903308

SFH M3x8

903306

SFH M3x6

903308

SFH M3x8

8. FINAL ASSEMBLY

DOUBLE-SIDED TAPE

(NOT INCLUDED)

RECEIVER

(NOT INCLUDED)

SPEED CONTROLLER

(NOT INCLUDED)

Feed the receiver wire into the antenna tube

3x8mm

3x6mm

MOTOR

(NOT INCLUDED)

When installing the motor on the bulkhead, rotate the spur

gear so the motor screw can be installed through a hole in the

spur gear. See the detail image below.

Adjust the motor so the pinion meshes with the spur gear

properly. Make sure the gear mesh is not too tight.

There should be a small amount of play between the teeth of

the pinion gear and the spur gear.

Suggested to use

3x2.5mm set screw

DETAIL

For tightening and loosening the pinion

set screw, use the indicated chassis hole.

BATTERY ASSEMBLY CONFIGURATION

LIPO ALTERNATIVE 6-CELL ALTERNATIVE

Check page 31 before taping the electronics to the chassis.

Use plastic nuts from the

Last Aid bag.

IMPORTANT!

Xray T3 User Manual

Questions and Answers: