5
KIT
The XRAY T3 comes partially pre-assembled. Before starting assembly, disassemble the chassis parts, noting the position and orientation of the parts, particularly the
bulkheads. Keep the parts, including the screw hardware, close at hand. In the assembly steps that follow, each section begins with a parts list. Parts indicated with
STYLE B are from the previously disassembled chassis parts in section 0.
CA
At the beginning of each section is an exploded view of the parts to be assembled. There is also a
list of all the parts and part numbers that are related to the assembly of that section.
The part descriptions are color-coded to make it easier for you to identify the source of a part.
Here are what the different colors mean:
STYLE A - indicates parts that are included in the bag marked for the section.
STYLE B - indicates parts that were set aside in Section 0.
STYLE C - indicates parts that are already assembled from previous steps.
0. KIT (FACTORY PRE-ASSEMBLED)
COLOR INDICATIONS
CORRECT
INCORRECT
Lightly file edges of battery slots to remove
sharp edges.
Please note that the US Foam-Spec 3.0mm
Thick Chassis requires the battery slots to be
filed more than the standard 2.5mm thick
chassis.
Do not file battery slots too much, or batteries
may protrude below the chassis bottom.
To protect and seal edges of graphite parts, sand edges smooth and then apply CA glue.
Do this for: chassis edges; filed battery slots, countersunk holes for front bumper screws.
For the US extra-thick chassis, we recommend rounding the bottom forward edge of the
chassis (using a file or sandpaper).
CA
Apply only a bit of CA glue on
the countersunk holes
903306
903306
302027-O
303052-O
303022-O
301129 (EU RUBBER-SPEC)
301130 (US FOAM-SPEC)
302027-O
303014-O
For the US thick chassis, we recommend rounding the bottom
forward edge of the chassis (using a file or sandpaper).
303022-O
30 1129 T3 CHASSIS GRAPHITE - 6-CELL - RUBBER-SPEC
30 1130 T3 CHASSIS GRAPHITE - 6-CELL - FOAM-SPEC
30 2027-O T3 ALU FRONT LOWER SUSP. ADJUST. BULKHEAD - ORANGE
30 3014-O T3 ALU RIGHT LAYSHAFT BULKHEAD - ORANGE
30 3022-O T3 ALU REAR LOWER SUSP. ADJUST. BULKHEAD - ORANGE
30 3052-O T3 ALU MOTOR MOUNT BULKHEAD - ORANGE
90 3306 HEX SCREW SFH M3x6 (10)
To Next Page
Loading...
Need help?
General
