Yaesu FT-2000 User Manual

Page 15FT-2000D OPERATING MANUAL
PLUG /CONNECTOR PINOUT DIAGRAMS
IMPORTANT NOTE:
The µ-TUNE, DMU, and PGM connectors are special connectors for this transceiver. Please do not connect any accessory
or other device not specifically approved by Vertex Standard. Failure to observe this precaution may cause damage not
covered by the Limited Warranty on this apparatus.
Do not use
2-conductor type plug
UP
+5V
DOWN
FAST
GND
PTT
MIC GND
MIC
+13V
TX GND
GND
BAND DATA A
BAND DATA B
BAND DATA C
BAND DATA D
TX INH
RTTY
BAND DATA
AF OUT
RCA PLUG KEY
MIC CAT
SIGNAL or
()
+
GND or
(-- )-
DATA IN
GND
PACKET PTT
DATA OUT
BUSY
SHIFT
RX OUT
PTT
GND
EXT SPKR
DC IN 13. 8 V
DC IN 50 V PACKET
ROT ROTATOR
()
PHONE
REM REMOTE
()
N/A
SERIAL OUT
SERIAL IN
N/A
GND
N/A
RTS
CTS
NC
CW ROTATION
SPEED
DIRECTION
GND
NC
CCW ROTATION
(as viewed from front panel)
(as viewed from rear panel)(as viewed from rear panel)
DOT DASH COMMON
For Internal Keyer
KEY GND
For Straight Key
(as viewed from rear panel)
(as viewed from rear panel)
(as viewed from rear panel)
(as viewed from rear panel)
(as viewed from rear panel)
SUB
(
VFO-B
)
MAIN
(
VFO-A
)
GND
SUB
(
VFO-B
)
MAIN
(
VFO-A
)
GND
GND
SIGNAL
GND
SIGNAL

Yaesu FT-2000 Specifications

General

Brand	Yaesu
Model	FT-2000
Category	Transceiver
Language	English