21
Transmitting the Registered DTMF Code
1. Press the Function key, then press the [9] key to toggle
between the “AUTO” and “MANUAL”. Select the “AUTO”.
Display Description
AUTO The registered DTMF code is automatically transmitted.
MANUAL
The DTMF code may be transmitted manually by pressing each numeric
key.
2. While pressing the PTT switch, press a numeric [1] to [9] key to DTMF memory num-
ber registered in “Setting the DTMF Memory”.
•
The DTMF code registered in the DTMF memory channel is automatically trans-
mitted.
•
Even after releasing the PTT switch, the transmission continues until the DTMF
code is completed. The transceiver is automatically returned to receive mode.
Manually Transmitting the DTMF Code
1. Set “MANUAL” referring to the above “Transmitting
the Registered DTMF Code”.
2. While pressing and holding the PTT switch to transmit, press each corresponding
key to send the DTMF code:
[0] to [9] key: 0 to 9
[▲] key
：
A
[▼] key
：
B
[P1] key
：
C
[P2] key
：
D
[
V/M] key:
Û
[#BAND] key: #
The transmission may continue for two seconds after releasing the PTT switch.
To Next Page
Loading...
Need help?
General
