10
BeFore you BegIn
Precautions
The
FTA-310
is capable of two-way communica-
tion on channels used for critical aviation safety
communications. Therefore, it is important that this
radio be kept away from children or other unauthor-
ized users at all times.
When making DC connections via the the optional
E-DC-5B/E-DC-6
DC cable, be absolutely certain
to observe the proper voltage level and polarity
guidelines. Do not connect this radio directly to any
24 ~ 28 Volt DC source, nor to AC power of any
kind. Connecting the
FTA-310
directly to a source
which exceeds 15.0 Volts DC will result in damage
to the unit. The Limited Warranty for this product
does not cover damage caused by the application of
improper voltage.
Do not dispose of the Ni-MH Battery Pack in a re.
Do not carry a Ni-MH Battery Pack in your pocket,
where keys or coins could short the terminals. This
could create a serious re/burn danger, and possibly
cause damage to the Ni-MH pack.
Although the
FTA-310
is designed to be Submers-
ible (3 ft., 30 min.), its enclosure is not designed to
guarantee protection from ingress of water under
extreme pressure. Do not allow the radio to become
submerged in deep water, and do not subject it to
water spray under pressure.
Belt Clip Installation
Connect the hanger to the rear of the
FTA-310
, with
the notch pointing directly up, using the supplied
screw (Fig 1). Use only the screw included with the
clip to mount the clip to the back of the
FTA-310
.
Clip the Quick-Draw Belt Clip onto your belt (Fig 2).
To install the
FTA-310
into the Quick-Draw Belt
Clip, align the hanger with the Quick-Draw Belt
Clip, and slide the
FTA-310
into its slot until a click
is heard (Fig 3).
To remove the
FTA-310
from the Quick-Draw Belt
Clip, rotate the
FTA-310
180 degrees, then slide the
FTA-310
out from the Quick-Draw Belt Clip (Fig 4).
To Next Page
Loading...
Need help?
General
