Components
13
EMU25952
Throttle lever
To increase speed, push the lever upward.
EMU25981
Throttle friction adjuster
An adjustable friction device within the aprons
restricts movement of the throttle lever ac-
cording to the operator’s preference.
When constant speed is desired, tighten the
adjuster to maintain the desired throttle set-
ting.
WARNING
EWM01480
Do not overtighten the friction adjuster. If
there is too much resistance, it could be
difficult to move the throttle lever, which
could result in an accident.
EMU25993
Engine shut-off cord (lanyard) and
clip
The clip must be attached to the engine shut-
off switch for the engine to run. The cord
should be attached to a secure place on the
operator’s clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the
cord will pull out the clip, stopping ignition to
the engine. This will prevent the boat from
running away under power. WARNING! At-
tach the engine shut-off cord to a secure
place on your clothing, or your arm or leg
while operating. Do not attach the cord to
clothing that could tear loose. Do not route
the cord where it could become entangled,
preventing it from functioning. Avoid acci-
dentally pulling the cord during normal
operation. Loss of engine power means
the loss of most steering control. Also,
without engine power, the boat could slow
rapidly. This could cause people and ob-
jects in the boat to be thrown forward.
[EWM00122]
EMU26001
Engine stop button
To open the ignition circuit and stop the en-
gine, push this button.
1. Clip
2. Cord
3. Engine shut-off switch
U6A12RE0.book Page 13 Friday, February 27, 2009 10:26 AM
To Next Page
Loading...
Need help?
General
