Connections
Owner’s Manual
32
About Dante Controller
Dante Controller is a software application that allows
configuration and audio routing of Dante networks. Use
this application if you plan to connect or set up
Dante-enabled devices (such as Dante-MY16-AUD) that
do not feature CL native support, or if you wish to set up
complicated signal routings on a Dante network. More
information is posted on the following website.
http://www.yamahaproaudio.com/
To run Dante Controller, a computer must feature a
GbE-compatible Ethernet connector.
Refer to the Dante Controller owner’s manual for details on
Dante Controller.
Connecting to I/O racks
This section explains how to connect the CL series to I/O
racks (such as Rio3224-D) in a daisy chain network and in
a star network (redundant network).
Daisy chain network
1. Before making any connections, turn on the
power to the CL unit, press the SETUP button,
press the DANTE SETUP button, and then
select DAISY CHAIN in the DANTE SETUP
screen.
2. Turn off the power to the CL unit.
3. Use the Dante connectors on the CL series
and I/O racks to connect them as follows:
4. Set the rotary switches and DIP switches on
the I/O racks as shown below.
5. Turn on the power to the CL series and the
I/O rack units.
6. Press the RACK button in the display screen.
7. Press the I/O RACK tab.
8. Press the DANTE INPUT PATCH button.
9. Press the AUTO SETUP button in the upper
right of the screen.
The AUTO SETUP button enables you to
automatically patch the devices in ascending order of
unit ID number, according to the settings of the
currently-connected I/O racks.
10. When a confirmation message appears, press
the OK button.
CL5
Rio3224-D (ID#1)
Rio3224-D (ID#2)
SECONDARY
PRIMARY
PRIMARY
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
(ID#1)
(ID#2)
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
To Next Page
Loading...
Need help?
General
Weight and Dimensions
