Basic components
22
When constant speed is desired, tighten the
adjuster to maintain the desired throttle set-
ting.
EMU25991
Engine shut-off switch
The clip must be attached to the engine shut-
off switch for the engine to run. The cord
should be attached to a secure place on the
operator’s clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the
cord will pull out the clip, stopping ignition to
the engine. This will prevent the boat from
running away under power.
WARNING
EWM00121
●
Attach the engine shut-off cord to a se-
cure place on your clothing, or your
arm or leg while operating.
●
Do not attach the cord to clothing that
could tear loose. Do not route the cord
where it could become entangled, pre-
venting it from functioning.
●
Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
NOTE:
The engine cannot be started with the clip re-
moved.
EMU26001
Engine stop button
To open the ignition circuit and stop the en-
gine, push this button.
ZMU02001
1. Cord
2. Clip
1. Cord
2. Clip
2
1
ZMU02003
ZMU02083
✩✮✴✬✤✥✤✲✣ ✥✥
©2019 Yamaha Motor Corporation, U.S.A.
To Next Page
Loading...
Need help?
General
