181
LS9-16/LS9-32
INITIALIZING THE LS9’s INTERNAL MEMORY
If an error occurs in the LS9’s internal memory, or if you have forgotten the password, you can use the following procedure to
initialize the internal memory.
CAUTION
• The entire contents of memory will be lost if you initialize the internal memory. Proceed with the following op-
eration only if you are very sure you want to do this.
While holding down the [SCENE MEMORY]
key of the DISPLAY ACCESS section, turn
on the power switch.
After the opening screen, the following startup menu
screen will appear.
1
According to the desired type of initializa-
tion, move the cursor to one of the buttons
in the MODE SELECT field, and press the
[ENTER] key.
INITIALIZE ALL MEMORIES button
The entire memory including scene memories and libraries
will be returned to their factory-set condition.
INITIALIZE CURRENT MEMORIES button
The contents of memory except for scene memories and
libraries will be returned to its factory-set condition.
To execute the Initialize operation, move the
cursor to the INITIALIZE button located in
the dialog box at the left side of the screen,
and press the [ENTER] key.
A dialog box will ask you to confi rm the operation.
2
3
:
.
@
q MODE SELECT fi eld
w INITIALIZE ALL MEMORIES b
utton
e INITIALIZE CURRENT MEMORIES button
Move the cursor to the OK button of the dia-
log box and press the [ENTER] key.
Initialization will begin.
NOTE
• Do not press any key until initialization has been completed.
4
When initialization has been completed, move
the cursor to the EXIT button and press the
[ENTER] key.
The console will start up in normal operating mode.
NOTE
• If the backup battery voltage is low, or if an error occurs
in the internal memory, a warning dialog box will appear,
and then the initialization menu will appear. If the warning
dialog box appears, and you select the EXIT button
to start up in normal operating mode, Yamaha cannot
guarantee that the unit will operate correctly.
HINT
• Instead of using the EXIT button, you can also select a
different button of the MODE SELECT fi eld.
5
To Next Page
Loading...
Need help?
General