To Next Page

To Previous Page

Reference Pattern Mode

Pattern Edit mode

244

Owner’s Manual

Same as in the Song Edit mode. See page 225.

The Pattern Job mode contains a comprehensive set of editing tools and functions you can use to change the sound of the Pattern. It also

includes a variety of convenient operations, such as copying or erasing data.

After setting parameters as required from the selected display, press the [ENTER] button to execute the Job.

An “Executing...” message is shown when it takes a short amount of time to execute the Job. Never attempt to turn off the power while an “Executing...”

message is shown. Turning the power off in this state results in loss of all user data.

During Pattern Recording

[PATTERN] → Pattern selection → [I] (Record) → [F] (Play)

Realtime Recording

Refer to page 110 in the Quick Guide section.

Step Recording

Examples of Step Recording are described on page 238.

Parameters in the displays are the same as in the Song Record mode. See page 224.

Pattern Edit mode

[PATTERN] → Pattern selection → [EDIT]

Pattern Job mode

[PATTERN] → Pattern selection → [JOB]

[F1] UNDO/REDO

The Undo Job cancels the changes you made in your most recent recording session, editing session, or Job, restoring the data to its previous state. This allows

you to recover from accidental data loss.

Redo is available only after using Undo, and lets you restore the changes you made before undoing them.

Undo/Redo does not work with Sample Voice and Mixing Voice operations.

[F2] NOTE (Note data Job)

The Note data Jobs in the Pattern mode are basically same as in the Song Job mode. However, unlike

in the Song Job mode, Pattern Note data Jobs are applied to the phrases (001 - 256) and a selected

range in the phrase (measure : beat : clock).

01: Quantize

Same as in the Song Job mode. See page 227.

02: Modify Velocity

Same as in the Song Job mode. See page 227.

03: Modify Gate Time

Same as in the Song Job mode. See page 227.

04: Crescendo