Special features
4-3
1
2
3
4
5
6
7
8
9
10
11
12
Resetting the traction control sys-
tem
The traction control system will auto-
matically disable when:
the front wheel or rear wheel
comes off the ground while riding.
excessive rear wheel spin is de-
tected while riding.
either wheel is rotated with the key
turned to “ON” (such as when per-
forming maintenance).
If the traction control system is dis-
abled, both the “ ” indicator light and
the “ ” warning light will come on.
Should this occur, try resetting the sys-
tem as follows.
1. Stop the vehicle and turn the key
to “OFF”.
2. Wait a few seconds and then turn
the key back to “ON”.
3. The “ ” indicator light should turn
off and the system be enabled.
If the “ ” indicator light remains on af-
ter resetting, the vehicle may still be rid-
den; however, have a Yamaha dealer
check the vehicle as soon as possible.
4. Have a Yamaha dealer check the
vehicle and turn off the “ ” warn-
ing light.
EAU78130
Quick shift system
The quick shift system (QS) allows for
full-throttle, clutch lever-less, electroni-
cally-assisted upshifts. When the shift
switch detects motion in the shift pedal
(page 5-12), engine power and drive
torque are momentarily adjusted to al-
low the upshift to occur.
This system requires an accessory
part to be activated. Contact your
Yamaha dealer for details.
The quick shift system operates
when traveling at least 20 km/h (12
mi/h) with an engine speed of 2300
r/min or higher, and only when ac-
celerating.
It does not operate when the clutch
lever is pulled.
BS2-9-13.book 3 ページ ２０１９年７月２５日 木曜日 午前１１時１分
To Next Page
Loading...
Need help?
General
