Operation
58
2. Press the power trim and tilt switch “ ”
(up) until the outboard motor has tilted
up completely.
3. Pull the tilt support lever toward you to
support the engine. WARNING! After
tilting the outboard motor, be sure to
support it with the tilt support knob or
tilt support lever. Otherwise the out-
board motor could fall back down
suddenly if oil in the power trim and
tilt unit or in the power tilt unit loses
pressure.
[EWM00262]
NOTICE: Do not use
the tilt support lever or knob when
trailering the boat. The outboard mo-
tor could shake loose from the tilt
support and fall. If the motor cannot
be trailered in the normal running po-
sition, use an additional support de-
vice to secure it in the tilt position.
For more detailed information, see
page 61.
[ECM01641]
4. Models equipped with trim rods: Once
the outboard motor is supported with the
tilt support lever, press the power trim
and tilt switch “ ” (down) to retract the
trim rods. NOTICE: Make sure that the
trim rods retracts completely during
mooring. This protects the rods from
marine growth and corrosion, which
could damage the power trim and tilt
mechanism.
[ECM00252]
68J-9-1G.book 58 ページ ２０１１年１２月１６日 金曜日 午後１２時４分
©2019 Yamaha Motor Corporation, U.S.A.
To Next Page
Loading...
Need help?
General
