Trouble Recovery
82
1. Stop the engine.
2. Remove the top cowling.
3. Disconnect the water detection switch
coupler. NOTICE: Be careful not to get
any water on the water detection
switch coupler, otherwise a malfunc-
tion could occur.
[ECM01950]
4. Unscrew the filter cup from the filter
housing. NOTICE: Be careful not to
twist the water detection switch lead
when unscrewing the filter cup.
[ECM01960]
5. Drain the water in the filter cup by soak-
ing it up with a rag.
6. Firmly screw the filter cup onto the filter
housing. NOTICE: Be careful not to
twist the water detection switch lead
when screwing the filter cup onto the
filter housing.
[ECM01970]
7. Connect the water detection switch cou-
pler securely until a click is heard.
8. Install the top cowling.
9. Start the engine and make sure that the
water separator-alert indicator remains
off. Have a Yamaha dealer inspect the
outboard motor after returning to port.
1. Water separator-alert indicator
1. Water detection switch coupler
1. Filter cup
2. Water detection switch lead
1. Water detection switch coupler
68J-9-1G.book 82 ページ ２０１１年１２月１６日 金曜日 午後１２時４分
©2019 Yamaha Motor Corporation, U.S.A.
To Next Page
Loading...
Need help?
General
