model no. 060-1984-8 | contact us: 1.866.523.5218model no. 060-1984-8 | contact us: 1.866.523.5218
14
Warning: Always wear eye protection. Never lean over the
trimmer head. Rocks or debris can ricochet or be thrown into
eyes and face and cause blindness or other serious injury.
Warning: Make sure that line is fed out before operation. Make sure
motor is up to full speed before trimming.
Operation Instructions
1. SWITCH ON/OFF
To switch on, press the lock-off button rst, then the On/Off switch (see Fig. F).
To switch off, release the On/Off switch.
2. TWO-SPEED GEAR CONTROL
The trimmer has a two-speed gear control designed for working at Low (mark is 1) or High
(mark is 2) speeds (see Fig. G). Select either Low or High speed according to the required
working condition.
3. Trimming
1) Keep the trimmer head at an angle of about 30° to the ground when trimming (see Fig. H1).
2) Do not cut wet grass because it tends to stick to the trimmer head and guard, prevents
proper discharge of grass clippings, and could cause you to slip and fall.
3) Regularly remove clippings and dirt around the trimmer head with a switched off trimmer.
4) Work rhythmically, stand rmly with your feet apart. Cut from right to left so the trimmings will be
thrown away from the work area (see Fig. H2).
5) When cutting long or high grass, please make sure that you cut this down in 2 to 3 stages (see Fig.
H3，H4).
6) Do not move the trimmer too fast as this will result in ineffective cutting and possible damage.
A2
A1
C2
C1
B
E1
E2
G
F
H2
H1
H4
H3
J1
I
J3
J2
K2
J4
K1
LOW
High
1
2
To Next Page
Loading...
Need help?
General