6 Keypad
YASKAWA ELECTRIC TOEP C710617 17D YASKAWA AC Drive GA700 Initial Steps EN 7
No. Name Functions
E
LO/RE LED
Illuminates to identify when the drive is operating in LOCAL Mode.
The LED turns OFF when the drive is operating in REMOTE Mode.
Note:
• LOCAL Mode: The keypad controls the Run command and frequency reference. Use the keypad to
enter Run/Stop commands and the frequency reference command.
• REMOTE Mode: The control circuit terminal or serial transmission device controls the Run
command and frequency reference. Use the frequency reference source entered in b1-01 [Frequency
Reference Selection 1] and the Run command source selected in b1-02 [Run Command Selection 1].
F
LO/RE Selection Key
Switches drive control for the Run command and frequency reference between the keypad (LOCAL) and
an external source (REMOTE).
Note:
• Stop operation in Drive Mode to enable the LO/RE Selection Key. Set o2-01 = 0 [LO/RE Key
Function Selection = Disabled] to disable when switching from REMOTE to LOCAL will
have a negative effect on system performance.
• The drive will not switch between LOCAL and REMOTE when it is receiving a Run command from
an external source.
G
STOP Key
Stops drive operation.
Note:
Uses a stop-priority circuit. Push to stop the motor even when a Run command is active at
MFDI terminals. Set o2-02 = 0 [STOP Key Function Selection = Disabled] to disable the priority in
.
H
Left Arrow Key Moves the cursor to the left.
Up Arrow Key/Down
Arrow Key
/
• Scrolls up or down to display the next item or the previous item.
• Selects parameter numbers, and increments or decrements setting values.
Right Arrow Key
(RESET)
• Moves the cursor to the right.
• Continues to the next screen.
• Restarts the drive to clear a fault.
ENTER Key
• Enters parameter values and settings.
• Selects menu items to move the user between keypad displays.
• Selects each mode, parameter, and set value.
I
RUN Key
Starts the drive in LOCAL mode.
Starts the operation in Auto-Tuning Mode.
Note:
Push on the keypad to set the drive to LOCAL Mode before using the keypad to operate the
motor.
J
USB Terminal Insertion point for a mini USB cable. Use the mini USB cable to connect the drive to a PC.
K RJ-45 Connector Connects the keypad directly to the drive.
L Clock Battery Cover Cover for the customer-supplied clock battery.
WARNING
Sudden Movement Hazard. Remove all persons and objects from the area around the drive, motor, and
machine area before switching control sources when b1-07 = 1 [LOCAL/REMOTE Run Selection = Accept Existing RUN
Command]. Failure to obey can cause death or serious injury.
EN
To Next Page
Loading...
Need help?
General