Recovery Mode on Yealink IP phones
6
Using Recovery Mode and Runing Backup
System on Yealink IP Phones
This section introduces how to enter recovery mode and run the backup system on Yealink IP phones
step by step.
For Dual System Devices
This section is only applicable to SIP phone series including SIP-T42U, SIP-T43U, SIP-T46U, SIP-T48U,
SIP-T57W, SIP-T54W, SIP-T53W, SIP-T53, SIP-T53C, and VP59.
This feature can only be supported on new factory phones running firmware version 86 or later.
Procedures
1. Long press (Speakerphone key) and reconnect the power adapter to trigger the recovery
mode. Do not release until the recovery mode wizard appears on the phone LCD screen.
2. Press 1 to run the backup system.
Using Recovery Mode on Yealink IP Phones
(HTTP Server)
This section introduces how to perform recovery mode using the HTTP server on Yealink IP phones step
by step.
For SIP Phone Series
This section is only applicable to SIP phone series including SIP-T27G, SIP-T30, SIP-T30P, SIP-T31,
SIP-T31P, SIP-T31G, SIP-T33P, SIP-T33G, SIP-T41S, SIP-T42S, SIP-T46S, SIP-T48S, SIP-T58A,
CP960, and CP920.
This feature can only be supported on new factory phones running firmware version 86 or later.
Procedures
To Next Page
Loading...
Need help?
General