Call Features
414
Permitted
Values
0-Disabled
1-Enabled, the recorded calls will be saved to the USB flash drive.
Default
0
Supported
Devices
T57W, T54W, T53W, T53, T48U, T48S, T48G, T46U, T46S, T46G, T43U, T42U, T42S, T41S, T29G,
T27G, CP920
Parameter
features.auto_recording.enable <y0000000000xx>.cfg
Description
It enables or disables the USB automatic recording feature.
Note: It works only if “features.usb_call_recording.enable” is set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
0
Supported
Devices
T57W, T54W, T53W, T53, T48U, T48S, T48G, T46U, T46S, T46G, T43U, T42U, T42S, T41S, T29G,
T27G, CP920
Parameter
features.idle_recording.enable <y0000000000xx>.cfg
Description
It enables or disables the USB idle recording feature.
Note: It works only if “features.usb_call_recording.enable” is set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
0
Supported
Devices
CP920
Multicast Paging
Multicast Paging allows you to easily and quickly broadcast instant audio announcements to users who are listen-
ing to a specific multicast group on a specific channel.
Yealink phones support the following 31 channels:
l
0: Broadcasts are sent to channel 0. Note that the Yealink phones running firmware version 80 or earlier can be
regarded as listening to channel 0. It is the default channel.
l
1 to 25: Broadcasts are sent to channel 1 to 25. We recommend that you specify these channels when broad-
casting with Polycom phones which have 25 channels you can listen to.
l
26 to 30: Broadcasts are sent to channel 26 to 30.
The phones can only send and receives broadcasts to/from the listened channels. Other channels’ broadcasts will
be ignored automatically by the IP phone.
Topics
Multicast Paging Group Configuration
Multicast Listening Group Configuration
Multicast Paging Settings
To Next Page
Loading...
Need help?
General