After enabling LLDP Learn, telephone can
automatically learn the data of DSCP, 802.1p, VLAN
ID from the switch. If the data is different from the
data of the LLDP server, telephone will change its
own value as the value of the switch(Synchronous
with VLAN in switch)
The time interval of sending LLDP Packet
Enable DSCP by selecting it
Specify the value of the SIP DSCP
Specify the value of the Audio RTP DSCP
Enable WAN Port VLAN by selecting it
Specify the value of the WAN Port VLAN ID, the
range of the value is 0-4095
Specify the value of the signal 8021.p priority, the
range of the value is 0-7
Specify the value of the voice 8021.p priority, the
range of the value is 0-7
Follow WAN: Follow the WAN ID
Disable: Disable Port VALN
Enable: Enable Port VLAN and specify the Port
VLAN ID different from WAN ID
Specify the value of the Port VLAN ID different from
WAN ID, the range of the value is 0-4095
Service Port
You can set the port of telnet/HTTP/RTP by this page.