Subject to chan
e without notice. Printed in U.S.A.
Cop
ri
ht © b
Unitar
Products Group 2000. All ri
hts reserved. Supersedes: 550.13-TG2Y (799) 550.13-TG2Y (1001)
Unitary 5005 Norman
Products York OK
Group Drive 73069
GUIDE SPECIFICATIONS
EACH UNIT SHALL BE:
• Covered b
a 1-
ear limited parts warrant
on the com-
plete unit.
• In current production with published literature available
to check performance, limitations, specifications, power
requirements, dimensions, operation and appearance,
and
• Equipped with a V-belt drive that:
a. Is rated at least 25% above the required HP.
b. Will permit the blower RPM to be adjusted to meet
the exact CFM requirement of the s
stem.
EACH UNIT ENCLOSURE SHALL HAVE:
• A steel an
le frame to provide the ri
id support required
for shippin
, ri
in
and
ears of dependable operation.
• Exterior panels of 18
au
e steel, finished with baked
enamel to provide a lon
lastin
qualit
appearance
• Removable panels to provide eas
access to the internal
components for maintenance and service, and,
• A filter rack with 1” filters.
THE DIMENSIONS OF EACH UNIT SHALL NOT
EXCEED THOSE SPECIFIED.
THE BLOWER MOTOR SHALL:
• Be mounted within the insulated cabinet to minimize the
transmission of sound to the surroundin
space, and
• Have a service factor of 1.15
THE EVAPORATOR COIL SHALL:
• Consist of copper tubes arran
ed in sta
ered rows,
mechanicall
expanded into aluminum fins,
• Be draw-throu
h, and
• Include factor
-mounted distributors, expansion valves
and solenoid valves for both capacit
reduction and
pumpdown.
THE BLOWER WHEELS SHALL
• Be d
namicall
balanced to minimize the levels of sound
and vibration
enerated b
the unit
To Previous Page
Need help?
General
