YORK INTERNATIONAL
2
FORM 150.63-RP5 (903)
Work on electronic equipment should not be undertaken unless the individual(s) have been
trained in the proper maintenance of equipment and is (are) familiar with its potential hazards.
Shut off power supply to the equipment before beginning work and follow lockout procedures.
When working inside equipment with power off, take care to discharge every capacitor likely to
hold dan ger ous potential.
Be careful not to contact high voltage connections when installing or operating this equipment.
LOW VOLTAGE
DO NOT be misled by the term “low voltage.” Voltages as low as 50 volts may cause death.
WARNING
HIGH VOLTAGE
Is used in the operation of this equipment.
DEATH OR SERIOUS INJURY
may result if personnel fail to observe safety precautions.
TABLE OF CONTENTS
CONDENSER COILS
FAN
PIPING
COMPRESSOR
CONTROL AND POWER PANELS
CHILLER OP TIONS
PAGE
UNIT NO MEN CLA TURE NAMEPLATE ENGINEERING DATA ...........................................3
CONDENSER COIL COMPONENTS ..................................................................................4
FAN COMPONENTS ............................................................................................................6
REFRIGERANT PIPING COMPONENTS............................................................................7
COMPRESSOR ..................................................................................................................10
CONTROL PANEL AND POWER PANEL...........................................................................16
SENSOR HARNESS...........................................................................................................68
TRANSDUCERS, PRESSURE CUTOUTS AND TEMP SENSORS ...................................71
WIRE HARNESS CONNECTORS-FIELD REPLACEMENT PART NUMBERS ...............72
YCUL CHILLER OPTIONS - KITS ......................................................................................73
ENCLOSURE KIT OPTIONS ..............................................................................................75
REMOTE CONTROL CENTER ..........................................................................................80
REMOTE CURRENT/TEMPERATURE RESET PARTS BREAKDOWN ............................81
RECOMMENDED SPARE PARTS......................................................................................82
To Next Page
Loading...
Need help?
General
