FORM NO.: 6U5M-A11M-NB-EN
JOHNSON CONTROLS 4
GENERAL SAFETY GUIDELINES
This equipment is a relatively complicated apparatus.
During rigging, installation, operation, maintenance,
or service, individuals may be exposed to certain
components or conditions including, but not limited
to: heavy objects, refrigerants, materials under
pressure, rotating components, and both high and low
voltage. Each of these items has the potential, if
misused or handled improperly, to cause bodily injury
or death. It is the obligation and responsibility of
rigging, installation, and operating/service personnel
to identify and recognize these inherent hazards,
protect themselves, and proceed safely in completing
their tasks. Failure to comply with any of these
requirements could result in serious damage to the
equipment and the property in which it is situated, as
well as severe personal injury or death to themselves
and people at the site.
This document is intended for use by owner-authorized
rigging, installation, and operating/service personnel.
It is expected that these individuals possess
independent training that will enable them to perform
their assigned tasks properly and safely. It is essential
that, prior to performing any task on this equipment,
this individual shall have read and understood the on-
product labels, this document and any referenced
materials. This individual shall also be familiar with
and comply with all applicable industry and
governmental standards and regulations pertaining to
the task in question.
Pay attention to keep this document and you can
acquire it from local authorized YORK service center
in case it would be lost.
SAFETY SYMBOLS
The following symbols are used in this document to alert the reader to specific situations:
Indicates a possible hazardous
situation which will result in death or
serious injury if proper care is not
taken.
Indicates a potentially hazardous
situation which will result in possible
injuries or damage to equipment if
proper care is not taken.
Identifies a hazard which could lead to
damage to the machine, damage to
other equipment and/or environmental
pollution if proper care is not taken or
instructions and are not followed.
Highlights additional information
useful to the technician in completing
the work being performed properly.
External wiring, unless specified as an optional connection in the manufacturer’s product line,
is not to be connected inside the control cabinet. Devices such as relays, switches, transducers
and controls and any external wiring must not be installed inside the micro panel. All wiring
must be in accordance with Johnson Controls’ published specifications and must be performed
only by a qualified electrician. Johnson Controls will NOT be responsible for damage/problems
resulting from improper connections to the controls or application of improper control signals.
Failure to follow this warning will void the manufacturer’s warranty and cause serious damage
to property or personal injury.
Cooke Industries - Phone: +64 9 579 2185 Email: sales@cookeindustries.co.nz Web: www.cookeindustries.co.nz
To Next Page
Loading...
Need help?
General
