Problem Possible cause Remedy
The oven does not heat up. The
display shows Demo.
The demo mode is activated. 1. Deactivate the appliance.
2. Press and hold the button +.
3. When an acoustic signal
sounds, turn the knob for the
oven functions to the first
function. Demo flashes in the
display.
4. Turn the knob for the oven
functions to the off position.
5. Release the button +.
6. Turn the knob for the temper-
ature clockwise three times.
The acoustic signal sounds
three times. The demo mode
is deactivated.
The display shows an error code
that is not on this list.
There is an electronic fault. 1. Deactivate the appliance with
the house fuse or the safety
switch in the fuse box and ac-
tivate it again.
2. If the display shows the error
code again, contact the serv-
ice centre.
Steam and condensation collect
on the food and in the oven.
You left the dish in the oven for
too long.
Do not keep the dishes in the
oven for longer than 15 - 20 mi-
nutes after the cooking ends.
If you cannot find a solution to the problem
yourself, contact your dealer or the service cen-
tre.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the appliance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
Installation
Warning! Refer to the Safety chapters.
20
www.zanussi.com