EasyManuals Logo
Home>Zapi>Inverter>ZAPIMOS Series

Zapi ZAPIMOS Series User Manual

Zapi ZAPIMOS Series
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
Page 32
4.4 FUNCTION CONFIGURATION
4.4.a Traction
Using the CONFIG MENU of the programming console, the user can configure the follow-
ing functions (see "OPERATIONAL FEATURE" chapter for an explanation of "hydraulic
steering function") :
SUBMENU "SET OPTIONS"
1 HOUR COUNTER
- RUNNING: the counter registers travel time only.
- KEY ON: the counter registers when the "key" switch is closed.
2 BATTERY CHECK
- ON: the battery discharge level check is carried out; when the bat-
tery level reaches 10%, an alarm is signalled and the maximum current is reduced to
the half of the programmed value.
- OFF: the battery discharge level check is carried out but no alarm is
signalled.
3 CUTBACK MODE
- PRESENT: input B10 (Minifit), A28 (Amp Saab) is managed as a cutback
speed input.
- ABSENT: input B10 (Minifit), A28 (Amp Saab) is managed as an hand-
brake input.
4 HYDRO KEY ON
- ON / OFF: if this option is programmed ON the traction inverter manages
an hydraulic steering function when the "key" is switched ON (only if the "aux output
#1" option is programmed as "hydro contactor" or as "exclusive hydro").
5 STOP ON RAMP
- ON: the stop on ramp feature (truck electrically hold on a ramp) is
managed for a time established by "auxiliary time" parameter. After this time, the
behavior depends on the "aux output #1" option programmation (see also the follow-
ing table).
- OFF: the stop on ramp feature is not performed.
6 AUX OUTPUT #1
- BRAKE: output B9 (Minifit), A7 (Amp Saab) drives an electromagnetic
brake coil (see also the table below).
- HYDRO CONT.: the inverter manages an hydraulic steering function when the direc-
tion input or brake pedal input are active or a movement of the truck is detected.
- EX. HYDRO: the inverter manages an hydraulic steering function when the
exclusive hydro input is active.
7 PEDAL BRAKING
- ANALOG: the mechanical brake pedal has a switch and a potentiometer
installed. When the accelerator is released and the pedal brake is pushed the in-
verter performs an electrical braking whose intensity is proportional to the brake

Table of Contents

Other manuals for Zapi ZAPIMOS Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zapi ZAPIMOS Series and is the answer not in the manual?

Zapi ZAPIMOS Series Specifications

General IconGeneral
BrandZapi
ModelZAPIMOS Series
CategoryInverter
LanguageEnglish

Related product manuals