28
Programming of M-Bus address
(optional)
■
Select of the display „Adr0 000“
in level 3 (same for the additional
inputs „Adr1“ to „Adr3“).
■
Press the button for about 2 se-
conds (until the door symbol re-
appears) and then release. The
right digit starts ashing. With
one short push the value of the
digit is incremented.
■
With each long press, the se-
lected value will take over and
change to next digit (as soon as
desired character blink, release
the button). The new value is now
programmed.
■
If the desired value is reached
you have to press the button un-
til the number stops ashing and
the return to the menu is comple-
ted.
■
The programming process can
be repeated if necessary.
Note: If the editor is not terminated,
maybe changed values are being
saved when automatically return to
the main display.
Radio (optional)
General information
zelsius
®
-energy meters which have
an integrated radio interface are
marked for better visibility on the up-
per cover with the following symbol:
The radio interface is always deac-
tivated on delivery. To activate the
device, no software is required. Only
the activated sleep mode has to be
nished: Devices that are in sleep
mode (Display: SLEEP 1) must be
activated by at least ve second
press of the button until the energy
display appears. The radio energy
meters are equipped with an inter-
nal antenna.
Français English Deutsch
To Next Page
Loading...
Need help?
General
