Zephyr ALL-M90BBX User Manual

- 21 -
FIG.18
REMOTE BLOWER WIRING
1. Remove the covers from the wiring boxs and remove one knockouts.
2. Run 4-wire plus ground power cable from the remote blower to the remote blower wiring
box marked “motor connection” (Fig.18B).
3. Feed 6” of cable through the knockout opening and secure the cable to the wiring box with
an appropriate connector.
4. Make electrical connections at the hood (box marked 120 Vac input). Connect white-to-
white, black-to-black, green-to-ground (Fig.18A).
5. Make electrical connections (remote blower box marked “motor connection”). Connect
white-to-white, black-to-black, blue-to-blue, red-to-red, green-to-ground (Fig.18B).
6. Replace the wiring box covers and screws. Make sure wires are not pinched between the
cover and box.
External blower connection:
1. Make electrical connections at the remote blower (see instructions provided with the
remote blower).
REMOTE BLOWERHOOD WIRE
HARNESS
BOX MARKED
“120 VAC INPUT”
REMOTE
BLOWER
BOX
CONNECT:
WHITE-TO-WHITE,
BLACK-TO-BLACK,
GREEN-TO-GROUND.
A
B
CONNECT:
WHITE-TO-WHITE,
BLACK-TO-BLACK,
BLUE-TO-BLUE
RED-TO-RED
GREEN-TO-GROUND.
WHITE(COMMON)
BLACK(HIGH)
BLUE(MED)
RED(LOW)
GREEN(GROUND)
MOUNTING
SCREWS
3.9x6mm
GROUND

Zephyr ALL-M90BBX Specifications

General

Brand	Zephyr
Model	ALL-M90BBX
Category	Ventilation Hood
Language	English