Zephyr Vortex AK9028BS User Manual

18
Vortex Use, Care, and Installation Guide
VORTEX
INSERT
CORE
Installing the Filter (FIG. G):
1. Place bottom of filter into channel on hood.
2. Push filter handle in.
3. Pivot filter up and lock into place.
Maintenance
3
2
1
FIG. G
LumiLight LED
In the unlikely event that your LumiLight LED fails,
please contact Zephyr to order replacement parts.
See the list of parts and accessories page for part
numbers and contact information.
LED Removal (FIG. H):
1. Remove filter.
2. Remove (4) screws from inner brackets of face
place.
3. Disconnect LED light quick connector.
4. Push in the two side clips on the ends of the
LED light.
5. Push LED light through the light panel opening.
Push the clip
FIG. H

Zephyr Vortex AK9028BS Specifications

General

Color	stainless steel
Hood Type	insert
Venting Type	convertible
Temperature Sensor	no
Sones	5 sones
Control Type	slide
Delay Start	no
Interior Light	yes
Remote Control	no
Voltage	120 volts

Weight and Dimensions

Depth	17 1/2 inches
Height	19 1/10 inches
Width	28 3/8 inches
Net Weight	32.6 pounds