Run Mode JesterML Operating Manual
73-406-00 Issue 1.0 21 of 65
MONITOR
The monitor shows details of the current and next memories, as well as all submasters.
SPEED
The speed setting (set using the wheels when CHASES is selected) is used to adjust the speed of all
currently active chases. A relative adjustment is made to each chase. If Manual is selected on the
speed, then the INSERT button is used to step chases on the memory stack. On the JesterML24, if
the Flash Mode (set using the Multi-Function-Keys when SPECIAL is selected) is set to Go, then the
submaster flash buttons can be used to step chases on submasters. If the SHIFT button is held down
when the speed is adjusted, then only the selected chase is affected.
DIRECTION
The direction options (set using the Multi-Function-Keys when CHASES is selected) can be used to
override the direction of all currently active chases. If the SHIFT button is held down when the
direction is adjusted, then only the selected chase is affected.
ATTACK
The attack options (set using the Multi-Function-Keys when CHASES is selected) can be used to
override the attack options of all currently active chases. If the SHIFT button is held down when the
attack options are adjusted, then only the selected chase is adjusted.
PROGRAM/GO
The PROGRAM/GO button is used to initiate a crossfade between the memory currently being output
and the next memory as indicated by the Main LCD.
Pressing the PROGRAM/GO button automatically increments the memory number in the Main LCD,
and the selection on the monitor.
Pressing PROGRAM/GO with SHIFT held down acts as a PAUSE button, stopping the crossfade
which is currently active. The crossfade can then be restarted by pressing the PROGRAM/GO button
again.
The PROGRAM/GO button is normally illuminated green in Run Mode. When a crossfade is paused,
it flashes green. While a crossfade is in progress, it blinks from green to yellow.
EDIT
The EDIT button also works in RUN Mode, to allow the selected memory/submaster to be quickly
edited. When pressed, the desk will temporarily change to PROGRAM Mode. Once edits have been
saved, the desk will automatically return to RUN Mode.
NOTES
Remote Go
Pressing a switch connected to the Remote Input jack socket on the back panel has
the same effect as pressing the PROGRAM/GO button, by default. This can be
altered in SETUP.
Entering Run Mode
1. If the desk is in PRESET Mode or SETUP Mode, press and hold the MODE
button for 1 second. The desk will change to PROGRAM Mode. When the desk
is in PROGRAM Mode press the MODE button to enter RUN Mode.
2. Set all the PRESET faders to zero (JesterML24 only)
3. Set the A MASTER and B MASTER to zero, and set the MEMORY MASTER to
full.
4. Set the GRAND MASTER to full and ensure that blackout is not active (the LED in
the BLACKOUT button is off).
To Next Page
Loading...
Need help?
General