24
When do you need to calibrate the stabilizer?
When How
a) Slight deviation is found in the tilt angle of the camera in
level position after startup.
b) Slight deviation is found in the roll angle of the camera in
level position after startup.
c) Frequent small angle correction is found when the
camera is in level position while the stabilizer stays still.
Initialize the
stabilizer
a) Slight deviation is still found in level position after the
initialization of the stabilizer.
b) Stabilizer unused for a long time.
c) Too large temperature difference between operation
environments.
Conduct six-side
calibration
Slight deviation is still found in the tilt or roll angle of the
camera in level position after the initialization and six-side
calibration of the stabilizer.
Fine tune motor
force
Calibration and Firmware Upgrade
Please calibrate the stabilizer when necessary to ensure normal use.
Initialization Method
1. Correctly install the batteries.
2. Hold the camera mounting plate with one hand, long press the power button to
start up the stabilizer; Long press the Mode button to enter the standby mode
while holding the camera mounting plate through the whole process in case of
start-up failure.
3. Put the stabilizer still on a table surface, wait for about 30 sec., and the
stabilizer will automatically complete initialization.
If the angle deviation still persists after the initialization, please try again
following the procedure.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
