Zojirushi cv-dcc40 User Manual

CLEANING AND MAINTENANCE
Always unplug the Power Cord,
dispose all water, and allow to cool
completely before cleaning .
411H•]i:9 •oo not attempt to dry the product by turning it upside down when the bottom is wet. (Water may get inside
the body and cause 1t to break or rust.)
•Do not use the following :
•
Thinner and bleach . (Doing so may cause discoloration, crack , degradation and corrosion .)
•
Polishing powder , nylon brushes, anything made with metal , eraser pads, hard nylon sponges and abrasive cleaners . (Doing so
may cause corrosion .)
•
Detergent. (Hot water may spill out, resulting in scalds or damage . Doing so may cause unwanted odor .)
•Do not use the scrub brushes for any portions other than the Filter . (Doing so may cause corrosion .)
•when
using chemical treated cloths , do not rub too hard or leave them on the product for a long time as the surfaces of the product
may be damaged by chemical reactions .
•Do not use a dishwasher or dish dryer for cleaning or drying . (May cause the plastic parts to deform .)
•Before storing the product for a longer period of time , dry it completely and pack in a plastic bag to prevent odors from being absorbed .
Inner Lid
Wipe with a soft wet sponge.
Inner Container
Perform the Citric Acid Cleaning
(see pg.17) periodically.
Body/Upper Lid
Wipe clean with a
damp well-wrung cloth .
•Do not wash any part of the Body, Control
Panel or Water Level Gauge with water.
(May cause malfunction or rust.)
Especially when ...
•Red rust-like spotting is visible on the Inner Container .
•Milky
white or gray discoloration and/or filmy objects
are found in the water .
•Boiling
is louder than usual.
•Hot water has an odor.
(The condition of the Inner Container will vary
depending on the water quality and frequency of use.)
Filter
Remove the Filter from the Inner
Container and wash with a soft brush .
Pull the Filter up to release, and press
down firmly to attach .
If you find it difficult to clean the Filter , replace
it with a new one . (see pg . 17)
!
't
•
•Never
use the product without installing the Filter .
(The Filter prevents foreign objects from entering the
Electric Pump and obstructing the flow of hot water .)
i#•fiJNd•it• ■ Wipe clean with a dry cloth . )
How To REPLACE THE INNER
LID
GASKET
Th~lnnerlidGasketmayneedtobereplaceddue
to time and wear. Check It about once a year .
Wipe new Inner Lid Gaskets with a wet soft sponge before attaching to the Inner Lid.
To remove the Inner Lid Gasket
G)Remove the three screws, and remove the Inner Lid.
eoo not lose these screws .
®Remove the Inner Lid Gasket which is installed on the Inner
Lid.
After removing the Inner Lid, check the plastic part of the
Upper Lid for abnormalities.
-+If this part is discolored or if it feels rough to the touch ,
replace it (there will be a charge for this).
When the Inner Lid
Gasket takes on a
white discoloration.
Please purchase
and replace with a
new one.
Screws (x3)
►
Inner Lid
d::,i R-lnner Lid
Ill Gasket
Inner Lid Gasket
0
Inner Lid
~
To attach the Inner Lid Gasket
G)Fit the Inner Lid Gasket securely to the outer circumference
as shown in the figure.
®Place
them correctly onto the Upper Lid and tighten the
screws securely.
Hot water may leak from the gap between the Upper Lid and the
Body when tilted if the Inner Lid Gasket becomes old and turns
white. This may result in scalds. If hot water spews from the gap or
there is steam even after replacing the Inner Lid Gasket, other parts
may be in need of repair. Please contact Zojirushi Customer Service.
16

Zojirushi cv-dcc40 Specifications

General

Brand	Zojirushi
Model	cv-dcc40
Category	Boiler
Language	English