Zojirushi cv-dcc40 User Manual

Q&A ON PRODUCT USE
18
Is it okay to use the product for
heating liquids other than water?
Do not fill the product with any liquid other than water. It may cause
malfunction, or may overflow and cause scalding.
pg.3
Does the water need to be
changed every day?
To prevent scale from building up, please change the water at least once a
day .
pg.10
Is it okay to use mineral water
or Alkalized Ionic water?
Yes . However, when mineral or Alkalized Ionic water is used, a floating
residue may develop or milky white substance may form on the surface of
the Inner Container. This is due to the ingredients in the water and is
harmless to your health . Frequent cleaning is recommended .
pg . 9
pg.17
I
accidentally drank water while
performing the Citric Acid Cleaning .
Is this harmful to my health?
Please follow the instructions shown on the package of the citric acid
cleaner CD-K03E-JU .
Is it okay to go out while the
product is turned on?
It is safe to use the product unattended as it has an Automatic Shut-Off function
(power to the heater will be automatically turned off), which will be activated once it
is empty of water . However be careful not to repeat the boiling process without filling
the Inner Container with water, as the Nonstick Coating may discolor and peel.
►
►
►
►
►
►
►
►
TROUBLESHOOTING GUIDE
Please check the following
points before calling for service.
Condition
Cause
(
Remedy
Water does not heat up.
Power Plug is not connected to an electrical outlet.
Connect the Power Plug .
Water does not boil.
The Quick Temp mode is selected. (Water does
not reach a boil under Quick Temp mode.)
Press the REBOIUQUICK TEMP button ,
select the regular Boil mode . (see pg . 14)
Hot water has a
disagreeable odor.
Scale or other residue has accumulated
on the Inner Container.
Perform citric acid cleaning .
(see pg . 17)
You have not performed citric acid
cleaning regularly.
• A mild plastic odor may be
noticeable with a new product.
This odor will gradually fade
away .
The product has not been used for a long
time.
Boil water, unlock and dispense
about 34 oz. (1 liter) of hot water .
Discard the remaining . (see pg . 9)
•
You may smell chlorine (used
for sterilization of tap water)
after boiling .
If tap water is used under Quick Temp mode, it
will take an additional 15 minutes after boiling
completes to remove up to 80% of the chlorine.
If this is an issue , use the regular
Boil mode instead. (see pg . 14)
Water pours out by itself from
the Spout or Steam Vent.
Check that the Inner Container is not filled
over the Maximum Water Level Line .
Pour out the excess water until it is
below the Maximum Water Level Line .
The Quick Temp mode cannot
be selected.
Is the 208°F or Vacuum Insulation Keep
Warm mode selected?
Select the 195, 175 or 160°F Keep
Warm mode, then select the Quick
Temp mode . (see pg . 14)
The 208°F or Vacuum Insulation Keep
Warm mode cannot be selected
during the Quick Temp mode .
You cannot select the 208°F or Vacuum Insulation
Keep Warm mode during the Quick Temp mode.
Water cools easily during
Vacuum Insulation Keep
Warm mode.
The amount of water kept warm is too
low.
Add water (below the Maximum
Water Level Line) and press the
REBOIUQUICK TEMP button .
Water does not dispense or
does not pour properly.
Hot water does not pour properly a few
minutes after boiling.
Open the Upper Lid to release air
bubbles, then close . (Be careful of
steam when opening the Upper Lid .)
Scale or other residue has accumulated
on the Inner Container and Filter .
Clean the Inner Container and Filter.
(see pg . 16)
The Automatic Dispense Lock is
engaged.
Press the UNLOCK button , then press
the DISPENSE button . (see pg . 10)
Power Plug is not connected to an electrical outlet.
Connect the Power Plug .
Calcium may build up in the water route and
prevent water from dispensing smoothly.
Perform citric acid cleaning .
(see pg . 17)
► (
)
►
►
►
►
►
►
►
►
►
►
►
►
► (
)
►
)

Zojirushi cv-dcc40 Specifications

General

Brand	Zojirushi
Model	cv-dcc40
Category	Boiler
Language	English