39
guarantee that interference will not occur in a particular
installation If this equipment does cause harmful interference to
radio or television reception, which can be deter mined by turning
the equipment off and on, the user is encourag ed to try to
correct the interfer ence by one or mor e of the following
measures:
-Reorient or r elocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the eq uipment i nto an outlet on a circuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for
help.
FCC Note:
Caution: Changes or modifications not expressly approved by
the party responsible for c omplianc e c ould voi d the user‘s
authority to operate the equipment.
RF Exposure Information (SAR)
This device is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy set
by the Federal Communications Commission of the United
States.
During SAR testing, this device was set to transmit at its highest
certified power level in all tested frequency bands, and placed in
positions that simulate RF exposure in usage against the head
with no separation, and near the body with the separation of 10
mm. Although the SAR is determined at the highest certified
power level, the actual SAR level of the device while oper ating
can be well below the maximum value. This is because the
device is designed to operate at multipl e power levels so as to
use only the power required to r each the network. In g eneral, the
To Next Page
Loading...
Need help?
General
