Default Settings 21
Default Settings Tab l e 5 shows the default settings for the Switch 4400:
Table 5 Default Settings
To make Webcache Support, Traffic Prioritization and Configuration Save
and Restore available on the SuperStack 3 Switch 4400 SE, upgrade the
product to the Switch 4400 SE Enhanced Software Upgrade (3C17207).
Feature Switch 4400
Automatic IP Configuration Enabled
Port Status Enabled
Port Speed 10/100 Mbps ports are auto-negotiated
Duplex Mode All fixed 10BASE-T and 100BASE-TX ports are
auto-negotiated
Power over Ethernet Enabled (3C17205 only)
Flow Control ■ Enabled in half duplex
■ Auto-negotiated in full duplex
Broadcast Storm Control Enabled
Virtual LANs (VLANs) All ports belong to the untagged Default VLAN
(VLAN 1) with IEEE Std 802.1Q-1998 learning
operational
Link Aggregation Control
Protocol (LACP)
Disabled per port
IP Multicast Filtering Filtering enabled
Rapid Spanning Tree Protocol Enabled
Fast Start ■ Enabled on front panel ports
■ Disabled on rear panel port
RMON Alarm Enabled
Smart Auto-Sensing Enabled
Webcache Support Disabled
Traffic Prioritization All ports prioritize NBX VoIP traffic (LAN and IP).
All ports set to “best effort” for all other traffic.
Port Security Disabled per port
Configuration Save and
Restore
Disabled
DUA1720-3AAA05.book Page 21 Friday, March 7, 2003 11:53 AM
To Next Page
Loading...
Need help?
General