18
TEMPERATURE MONITORING DEVICE COMEM DTI AND COMEM EDTI - INSTRUCTION MANUAL
—
6. Programming of the device
6.11 Configuration diagnostic probes
This function allows to enable or to disable the control on the
probes. This functionality controls the variation of the
temperature in a defined time. A flag raise if this variation is
higher than a set value.
6.12 Exit from the programming phase
Press the SET key or wait for about 8 seconds without to press
any key to come out of the programming phase.
It’s necessary to indicate the maximum variation temperature:
• FDC: min 5°C or max 30°C
and after the time in which to do the control:
• FDC: min 10” or max 90” (time in seconds)
decrease.
Confirm with ENTER.
FDC setting
FDC mode disabled FDC Off
FDC mode enabled FDC ON
Temperature configuration FDC
Min °C FDC
Max °C FDC
Time configuration FDC
Min in seconds FDC
Max in seconds FDC
To Next Page
Loading...
Need help?
General
