ABB Comem DTI User Manual

2
TEMPERATURE MONITORING DEVICE COMEM DTI AND COMEM EDTI - INSTRUCTION MANUAL
6. Programming of the device 11
6.1 Selection of the HOLD function 11
6.2 Selection of the number of active inputs 12
6.3 Control ventilation 12
6.4 Selection of the threshold of switch on and switch off
ventilation 13
6.5 Selection of the alarm and trip threshold 13
6.6 Selection of address network identification for the
communication of the serial port (MODBUS-RTU protocol) 14
6.7 Selection of the baud rate 14
6.8 Selection data bit and stop bit 15
6.9 Selection of the linked channel with the analogue output 16
6.10 Configuration output signal 17
6.11 Configuration diagnostic probes 18
6.12 Exit from the programming phase 18
7. Modality of tripping and restore 19
7.1 Alarm 19
7.2 Trip 19
7.3 To silence alarm 19
8. Diagnostic 20
9. Visualization of the maximum measured temperature 21
10. Visualization of the channels with the higher temperature 22
11. Test of the light signaling 22
12. Exclusion of the input probes not used 22
13. Technical features 23
14. Dimensions 24
15. Movement, transport and storage 25
16. Appendix A: MODBUS address. 26

ABB Comem DTI Specifications

General

Brand	ABB
Model	Comem DTI
Category	Measuring Instruments
Language	English