4 Software Configuration
INTRODUCTION
The following provides details on the software configuration of the MATRIX-2 Series hardware. Please follow
the steps contained within this section for proper setup and configuration.
TOOLS REQUIRED
The following tools will be required for proper configuration of the system:
• PC/Laptop
• Ethernet cross-over cable, or other network connection to your MATRIX-2 Series device
• Standard web-browser such as Windows Edge, Mozilla Firefox, Apple Safari, or other.
• MATRIX-2 Series License file pre-installed
• 24 V AC power source
CONNECTING TO A MATRIX-2 SERIES DEVICE
The MATRIX-2 Series device is shipped with a default IP address (
192.168.1.251
) and subnet mask
(
255.255.255.0
) on the primary Ethernet Port. Your laptop’s network card must be configured in a manner
where it may access this IP network setting. Refer to your operating system documentation for details on
how to configure your network card.
See
Ethernet Settings
on page 22 for details on how to reconfigure MATRIX-2 Series device IP Address.
LOG-IN
To log-in to the MATRIX-2 Series device:
1. With your PC’s network card configured, open any standard web browser.
2. Browse to the IP address of your MATRIX-2 Series device as defined during installation.
3. If your connection is successful, the main login page of ASPECT will be displayed:
4. Enter the case-sensitive default username and password into the fields provided.
5. Click the Log In
button.
To Next Page
Loading...
Need help?
General
