4.4 Examples
4.4.1 Configuring an external controller using Siemens Step7 PC tool
Description
This is an example of how to configure the PROFINET anybus device using the
Siemens Step7 PC tool. The procedure can be used with other tools as well. See
the documentation for your PLC configuration tool.
Configuring the anybus device
Use the procedure described in section Configuring the anybus device on page 26.
Configuring the external master
Use this procedure to configure a Siemens PLC to connect to the anybus device,
using Siemens Step 7.
The example uses a static IP address and no gateway.
NoteAction
Start Siemens Simatic Manager. On the
PLC menu, click Edit Ethernet Node.
1
xx0800000187
Click Browse.
Note
The PROFINET Anybus Device must
already be configured in the IRC5 control-
ler.
2
xx0800000199
Select the PROFINET Anybus Device to
configure and click OK.
Tip
Select a device in the list and click Flash.
The LED on the selected device will flash
repeatedly until Stop Flash is clicked.
3
Continues on next page
Application manual - PROFINET Anybus Device 29
3HAC050968-001 Revision: C
© Copyright 2008-2016 ABB. All rights reserved.
4 Configuring the anybus device
4.4.1 Configuring an external controller using Siemens Step7 PC tool
To Next Page
Loading...
Need help?
General
