To Next Page

To Previous Page

Drive configuration

Table 1. FPBA-01 configuration parameters – Group A

Note: Set also the extended Parameter Data (see SAP 61 in the

chapter Communication) to ensure proper operation of the

FPBA-01 with the drive.

1 FBA TYPE

This parameter shows the fieldbus adapter type as detected by

the drive. The value cannot be adjusted by the user.

If this parameter is undefined, the communication between the

drive and the module has not been established.

Par.

no.

Parameter name Alternative settings Default

setting

1 FBA TYPE (Read-only) PROFIBUS DP

2 NODE ADDRESS 0 to 126 3

3 BAUD RATE* (12000) 12 Mbit/s; (6000) 6 Mbit/s;

(3000) 3Mbit/s; (1500) 1.5 Mbit/s;

(500) 500 kbit/s; (187) 187.5 kbit/s;

(93) 93.75 kbit/s; (45) 45.45 kbit/s;

(19) 19.2 kbit/s; (9) 9.6 kbit/s

1500

4 TELEGRAM TYPE* (1) PPO 1; (2) PPO 2; (3) PPO 3;

(4) PPO 4; (5) PPO 5; (6) PPO 6;

(7) ST1; (8) ST2**

(Read-only)

(1) PPO 1

5PROFILE (0) PROFIdrive; (1) ABB Drives;

(2) Transparent 16;

(3) Transparent 32**;

(4) PROFIdrive positioning mode**

(1) ABB Drives

6 T16 SCALE 1 to 65535 100

*The value is automatically updated (Read-only).

**Only supported with an ACSM1/ACS850 drive.

ABB FPBA-01 User Manual

Other manuals for ABB FPBA-01