________________________________________________________________________________________________________
AC500-eCo - 30 -
Hardware Introduction
Connection plans and user software must be created so that all technical safety aspects, legal
regulations and standards are observed. In practice, possible shortcircuits and breakages must
not be able to lead to dangerous situations. The extent of resulting errors must be kept to a
minimum.
Use only ABB approved lithium battery modules!
At the end of the battery’s lifetime, always replace it only with a genuine battery module.
Never short-circuit or operate lithium batteries with the polarities reversed!
They are likely to overheat and explode. Avoid chance short circuiting and therefore do not store
batteries in metal containers and do not place them on metallic surfaces. Escaping lithium is a
health hazard.
Never charge lithium batteries!
Lithium batteries are primary cells and cannot be recharged. Attempts to charge lithium batteries
lead to overheating and possible explosions.
Dispose of lithium batteries environmentally consciously!
Do not open lithium batteries and never throw them into fires (risk of explosion). Do not dispose of
along with the household rubbish but in an environmentally conscious manner, in accordance to
local-authority regulations.
Additional notes
ATTENTION
Avoidance of electrostatic charging
Electrostatic charging can cause internal defects of the devices and
impair the proper function. Observe the following rules when handling
the system:
Touch an earthed object in order to discharge the electrostatic charging.
Wear a suitable earthed strap around your wrist.
Do not touch any connections or pins on the printed circuit boards.
Do not touch any circuits inside the devices.
If available, use a work place which is equipped with suitable
electrostatic discharge.
In order to avoid electrostatic charging, the devices must only be stored
when packed in suitable packaging material.
To Next Page
Loading...
Need help?
General
