Maintenance
36 RHDE250 ... 4000 (Contrac) 42/68-167-EN
Pos: 17.6 /Überschri ften/1.1/1-spa ltig/A - F/Bremseneinst ellung @ 10\mod_1181642242 218_3101.doc @ 103863
7.2 Brake adjustment
Pos: 17.7 /Wartung / Repara tur/Aktorik/ Antriebe/Allgemein/ Bremseneinstellun g @ 10\mod_1181641915859_ 3101.doc @ 103794
Warning - risk of injury!
Note that the actuator position may be changed accidentally by the repelling power of the
valve when the brake is released!
Since the brake is permanently released in AUT mode it is not exposed to mechanical wear.
Any readjustment is not necessary. Enables users to test the configuration software of the
brake.
Pos: 17.8 /Überschri ften/1.1/1-spa ltig/M - R/Ölwechsel @ 10\mod_11 81652527843_3101. doc @ 104243
7.3 Oil change
Pos: 17.9 /Wartung / Repara tur/Aktorik/ Antriebe/Elektr. Sc hwenkantriebe/Allge mein/Ölwechsel @ 10\ mod_1181632020265_3101. doc @ 103369
Important
Oils for different temperature ranges may not mixed. Dispose of old oil according to local
regulations. Make sure that the oil does not enter the water cycle.
Proceed as follows to drain or change the oil:
1. Provide a container capable of holding the expected oil quantity acc. to chapter Filling
cap
acity.
2. Open and remove the ventilation plug, see Fig. 3.
3. Un
screw the lowermost inspection plug and drain the oil.
4. Make sure all the oil is out of the actuator.
5. Screw in and tighten the oil drain plug.
6. Fill the container with the proper volume of oil and tighten the venting plug.
Pos: 17.10 /Wartung / Repar atur/Aktorik/ Antriebe/Elektr. Schwenkantriebe/Al lgemein/Schmiermit tel @ 10\mod_1181719095156_ 3101.doc @ 105134
Ambient temperature Oil types
(default oil filled with delivery)
-25 ... 60 °C (-13 ... 140 °F) Mobil SHC 629
-30 ... 40 °C (-22 ... 104 °F) Mobil SHC 626
Pos: 17.11 /==== === Seitenumbruch ======= = @ 0\mod_1126532365768_3101.d oc @ 3830
To Next Page
Loading...
Need help?
General
