TERR A DC WA LLBOX
2023 -20-06 30/40
• From left to right for the 1-phase unit (as showed in the following picture):
PE- terminal block green/yellow, L2 - terminal block grey, L1 - terminal block grey
12. Tighten the bolts. The advised torque value is 2.9Nm.
13. After terminating the wires, make sure to adjust the terminal blocks so they are properly aligned as
misalignment can occur while applying proper torque to the connectors (as shown in 208/240V termi-
nal layout above)
5.6 Instruction for Mounting the DC Wallbox Gun Holders
5.6.1 General
This document is intended to provide an instruction for service team / installers in order to
be able to properly install the terra DC wallbox gun holders.
5.6.2 General description
The Terra DC wallbox is provided with two types of gun holders. A standard gun holder is
provided with all the DC wallboxes. The standard Terra DC wallbox gun holder is illustrated
in Fig.1 and 2Error! Reference source not found.. An optional gun holder is also available a
s an optional / spare part and can be ordered as external kit. The optional gun holder is
illustrated in Fig. 3 and 4. All the above described gun holders include adapters for CCS or
Chademo charging guns.
To Next Page
Need help?
General
